custom Estimate
smoke alarm & co detector install
Hardwired, interconnected smoke and carbon monoxide detectors, installed where your home actually needs them.
Residential & Commmercial Electrical · Honest Work · Fair Prices
about this service
the alarm that works is the one wired to work
A battery-only smoke detector is better than nothing, but it's also the first thing that goes silent when a battery dies unnoticed. Hardwired, interconnected alarms solve that problem two ways: they run off your home's electrical system with battery backup, and when one alarm detects smoke or CO, every alarm in the house sounds, not just the one closest to the danger. That's the difference between waking up in time and not.
Because the right setup depends on how many units your home needs, whether existing wiring can be reused, and whether you're adding CO protection where it wasn't required when the house was built, this service is quoted rather than flat-rate. We'll take a look at your home's layout and give you a clear price before any work begins.
Replacing old units? Check t
Replacing old units? check the date first
Smoke alarms typically need replacing every 8–10 years and CO detectors every 5–7, even hardwired ones. If your units are original to an older home, it's worth having them swapped out even if they still seem to work.
where they're needed
code-guided placement
A smoke alarm inside every bedroom
A smoke alarm outside each sleeping area, in the hallway
At least one smoke alarm on every level of the home, including basements
A CO detector near sleeping areas in homes with gas appliances, fireplaces, or an attached garage
Additional units in larger homes so no alarm is too far from a bedroom to be heard
what we check
beyond just mounting the unit
Correct unit count & placement for your home's layout
Interconnection so all alarms sound together
Battery backup wired in for power outages
CO protection near gas appliances & garages
Old or expired units removed & replaced
Every unit tested for sound & sensor function
how it works
our process
we review your home's layout
Tell us your home's size and bedroom count, and whether you have existing hardwired units, and we'll confirm what's needed.
we confirm the estimate with you
You'll know the exact cost before any work begins, based on unit count and any new wiring required.
units installed & interconnected
We mount and wire each detector so they're interconnected and backed up with battery power.
tested before we leave
We test every unit individually and confirm the whole system sounds together as it should.
serving Maricopa & pinal counties
ready to get
started?
Whether it's a quick repair or a major upgrade, reach out and we'll walk you through exactly what
needs to be done. Straight answers. Fair prices. Done right.
LICENSE: ROC 367437
Follow us
